Hello
I'm working in a project using labview 8.5 and in the end of this i have
to communicate my spartan 3E board with one computer using two xbee.
If i do it with the RS 232 cable,
i haven't got any problem but if i try to put the xbee when i
compile apper this message:
ERROR: Xflow- Program map returned error code 2. Aborting flow
execution.
However, is impossible that the FPGA is full because i try done it the
last part alone and the problem persist. Therefore, I think that the
problem is in the configuration of it. To configure:
1.No characters sent for one second
2.Input three plus characters ("+++") within one second 3.No
characters sent for one second
I do it with a sequence before i send my information, but is something
wrong and i do a lot of different combination of different command and the
problem continues.
I hope that someone could help me.
Kind regard
Josu
