hi everyone, My name is Zhi and I have another problem with on my senior
project. Right now, we are trying to make labview communicate with an old
stage. Its model is Neat_310M ( I have its manual uploaded). I have
beening trying to make an simple communiation like wake up x-axis stage
and ask it to move relative 10000 steps. However, I can only sucessfully
do these two actions in hyper-terminal. When I used the VI i have set up,
the stage does not responding at all. my concern is that I did
not open the serial ****t properly because while I continuely run the VI, I
can still open and run the hyperterminal together. (i believe two
programs cannot share the ****t at the same time). my other concer is
that since the stage controller echo back whatever command i type ,
for example, I want to ask stage to move relatives 10000
steps, when I type the command, "mr", then the controller will echo
back "move relative". After it is echo, I enter the number and the stage
moves. I obeserved this kind of respond in hyperterminal. I am
wanderin if this kind of responds will cause the problem that i have.
thanks Message Edited by zhao.lin on 05-12-2008 07:14 PM
test 1.vi:
http://forums.ni.com/attachments/ni/170/323068/1/test
1.vi
Neat_310M_Manual.pdf:
http://forums.ni.com/attachments/ni/170/323068/2/Neat_310M_Manual.pdf
|
