I have created a FPGA vi that outputs a certain signal that I want to go
out a DIO and the RTSI. It goes out the DIO ok. But there
seems to be nothing going out the RTSI line. I've added the RTSI
resourse to the project, and all I do in the FPGA VI is configure the RTSI
as Write, and then simply run a boolean value into it, just like I do with
the DIO. What are the exact steps I need to take to configure the RTSI
trigger to be outputed? Do I need to go through Measurement and
Automation explorer and configure the RTSI cable somehow? I saw
something about this in the Help, but was a little unsure exactly what to
do. Thanks for your help,Rick
