Thank you for the Info. I have two CVF systems, one bought two years
ago on my W2000 Professional, and the much older one which I put and
tested on my laptop XP, just in case. Turns out that one woks fine.
So I found what I was looking for on the XP then found most of the
routes in the Develpoper Sutio on the W2000 were shaded as not
available.
I found I had to have a projct actually in place, with a workplace
before the I could get to
Project - Proj.Settings -Fortran Tab - Categories - General - Fortran
Data - LRECL
Pheu! No wonder I couldn't remember all that!
You see why I really like MS F77.
I just say at the prompt "For1 myprog" and I get a list of errors
(possible but rare) or it's done!
OK! To work!
On Apr 24, 11:41=A0am, dpb <n...@[EMAIL PROTECTED]
> wrote:
> > All the settings are under Project...Settings. =A0Then you'll get the
ta=
b
> > control that has the various tabs for General, Debug, Fortran, etc.,
...=
Would you believe I never tried that! Wa looking for "options" (all
over the place)
> > When you're at that point, my previous directions take over.
>
> Oh, I forgot and what you're probably remembering -- you can right-click
> the source file in the project tree view and the Settings tab control
> accessed from that path as well. =A0By this path, it only has the two
tabs=
> of General and Fortran.
>
> The difference is, settings here apply only to the single file, _not_
> the full project so you either have to do it for every file individually
> or use the Project...Settings route if there is more than one source
file.=
>
And that's good to know too!
Thanks!
|
