"Janusz Cyran" <lobster@[EMAIL PROTECTED]
> escribió en el mensaje
news:fsea06$p8r$1@[EMAIL PROTECTED]
> Hi,
>
> After installation of a program (Nero, to be more specific) the Clipper
> 5.2e
> program cannot be run any more and "Cannot execute " followed by the
name
> of
> the exe file is displayed in cmd window.
>
> Some more info:
>
> Operation system is Microsoft Windows XP version 5.1.2600 - such
> information
> is displayed by ver command. It can be add it is MediaCenter Windows.
>
> Before the Nero was installed, Clipper program run without any problems
> for
> years.
>
> If one puts in command line "program.exe", the information "Bad command
or
> file name" is displayed. If one puts "program" alone, "Cannot execute
> ...\program.exe" is displayed, which is not a normal behaviour, because
> normally in both cases the program is executed.
>
> Clipper program is linked with Blinker 5.1. Both real and protected
> versions
> give the same bad results.
>
> Deinstallation of Nero did not improve the situation.
>
> A test program in xHarbour runs without any problem.
>
> So it seems that now it is the problem with 16-bit programs. It is as if
> Nero had changed some system files and modified it so that the system
> cannot
> run 16-bit programs any more. Does it seem possible? If so, what
libraries
> can be relevant here?
>
> Any other ideas?
>
> Thanks a lot,
> JC
Hi Janusz
Why don't you try a system restore to a previous restore point?
This should leave your system as it was before.
My two cents, HTH.
--
Claudio Voskian
ICQ#: 18122595 - Aol/Msn/Skype/Y!: cvoskian
Buenos Aires - Argentina
|
