"Andrzej P. Wozniak" <uszer@[EMAIL PROTECTED]
> je napisao u poruci
interesnoj grupi:fruear$fc0$1@[EMAIL PROTECTED]
> Osoba podpisana jako sali <sali@[EMAIL PROTECTED]
> w artykule
> <news:frru2g$36s$1@[EMAIL PROTECTED]
> pisze:
>
>> "dlzc" <dlzc1@[EMAIL PROTECTED]
> wrote in message
>>
news:7432e7c7-8a2c-4a03-a975-67cff1ef3eb7@[EMAIL PROTECTED]
>> Dear sali:
> [...]
>>> There is no indication that this "job pause reset" is in any way
>>> associated with the printer hardware / firmware. This leaves driver
>>> and OpSys as the likely culprits.
>>
> You should copy the files together, not one after another.
> Use command like that:
>
> copy /b font-file + report-file LPT1
>
>> if "few seconds" is less than 7, the report is printed out using
>> font-file char shapes
>> if "few seconds" are greater than 7, the report is printed out by
>> printer's default font [ugly]
>
> It seems to be 5 seconds and it seems to be default job timeout.
>
yes, i know for copy together, but since this old app works by sending
first
the font def and later page ba page of report as they are getting created,
my first attempt is to find solution "on printer side" [to have hp be
compat
with old hp pcl5e], the second is to re-write the app
have you also personaly experienced this behaviour with hp2014?
i am quite sure that timeout is close to 7 sec, because have counter
[norton
be] between sending files, and counter gives me safe 120 ticks [tick is
1/18
sec]
|
